HRT-227CS – HART to Single Mode Fiber Converter

HRT-227CS – HART to Single Mode Fiber Converter

Marcas:

Datasheet, Manual e Outros

REF: HRT-227CS Categoria Tags: ,
  • Descrição
  • Informação adicional
  • Specs
  • Ordering

Descrição

  • Support HART Short/Long frame
  • Support HART Burst mode
  • Support point-to-point or multi-drop HART mode
  • Support connecting up to 15 HART slave devices
  • Allow two HART masters
  • Provide HC_Tool utility for module configuration
  • Support firmware update via ComPort
  • Fiber broken line detection
  • Fiber Type: SC ; Single mode ; 100 Base-FX
  • Fiber max. transmission distance up to 30 km
  • 4KV ESD Protection
  • Built-in Watchdog
  • Selectable 250Ω loop resistor
  • The HART port with the same Group ID can communicate with each other

Informação adicional

Modelos

HRT-227CS

HART Interface
Channel1
Connector2-pin screwed terminal block (HART+, HART-)
Loop ResistorSelectable 250 Ω loop resistor
HART DataOnly Digital Data
IsolationUL1577 Spec.
Fiber Interface
TypeSC Duplex type ; Single mode ; 100 Base-FX
Wave Length (nm)1310
Fiber Cable (μm)8.3/125, 8.7/125, 9/125 or 10/125
Transmission Distance (km)30 (indicative only)
Min. TX Output (dBm)-15
Max. TX Output (dBm)-8
Max. RX Sensitivity (dBm)-34
Max. RX Overload (dBm)-5
Budget (dBm)19
UART Interface
COM1RS-232 (TXD / RXD / GND) for configuration (1200, O, 8 ,1)
LED
Round LEDPWR, FB_Ack, FB_Err, HT_Err, HT_Tx and HT_Rx
Power
Power supplyUnregulated +10 ~ +30 VDC
ProtectionPower reverse polarity protection, Over-voltage brown-out protection
Power Consumption3W
Mechanism
InstallationDIN-Rail
Dimensions33.0 mm x 126 mm x 101 mm (W x L x H)
Environment
Operating Temp.-25 °C ~ +75 °C (-13 to 167ºF)
Storage Temp.-30 °C ~ +80 °C (-22 to 176ºF)
Humidity10% ~ 90% RH, non-condensing
HRT-227CS
HART to Single Mode Fiber Converter (RoHS)