I-7532 – Two-channel CAN Bus Isolated Bridge

I-7532 – Two-channel CAN Bus Isolated Bridge

Marcas:

Datasheet, Manual e Outros

Datasheet, Manual e Outros

REF: I-7532 Categoria: Tags: , ,
  • Descrição
  • Informação adicional
  • Specs
  • Ordering

Descrição

  • 82C250 CAN transceiver
  • 2500 VRMS photo coupler isolation on the CAN side
  • 3KV galvanic isolation among the power supply and 2 CAN channels
  • Support both CAN 2.0A and CAN 2.0B
  • Fully compatible with the ISO 11898-2 standard
  • Adjustable CAN bus baud rate from 5Kbps to 1Mbps or programmable user-defined baud rate
    (For firmware v1.01 or newer) (NEW)
  • Support CAN bus message acceptance filter configuration
    (For firmware v1.01 or newer) (NEW)
  • Provide I-7532 Utility for CAN bus message acceptance filter and user-defined CAN baud rate etc. configuration easily and quickly
    (For firmware v1.01 or newer) (NEW)
  • Support firmware update via CAN1 of I-7532
    (For firmware v1.02 or newer)
    (NEW)
  • CAN messages can be forwarded under another identifier
    (For firmware v1.03 or newer) (NEW)
  • Built-in jumper to select 120Ω terminal resistor
  • Watchdog inside
  • Up to 100 CAN nodes on each channel
  • Transmission distance up to 1 km on each CAN port
  • Removable terminal block, Mount easily on DIN-rail
  • 768 frame buffer for each CAN channel
  • The baud of each channel can be different for highly flexibility
  • Supports a range of baud rates from 10 kbps ~ 1 Mbps
  • Able to configure the CAN baud rate for each channel using a rotary switch
  • Extends the CAN transmission distance

Note: We have verified to drive 100 CAN nodes at the same time via one CAN port of I-7532.

Informação adicional

Modelos

I-7532, I-7532-G CR

CAN Interface
Transceiver
NXP 82C250
Channel number
2
Connector
4-pin screwed terminal block (CAN_GND, CAN_L, CAN_SHLD, CAN_H)
Baud Rate (bps)
Adjustable CAN bus baud rate from 5Kbps to 1Mbps or programmable user-defined baud rate
Isolation
3000 VDC for DC-to-DC, 2500 Vrms for photo-couple
Terminator Resistor
Jumper for 120 Ω terminator resistor
Specification
ISO-11898-2, CAN 2.0A and CAN 2.0B
Time Delay
[ 1Mbps (8-byte Data) ] ID-29bit => 156us ; ID-11bit => 134us
[ 5Kbps (8-byte Data) ] ID-29bit => 30ms ; ID-11bit => 25ms
Power
Power supply
Unregulated +10 ~ +30 VDC
Protection
Power reverse polarity protection, Over-voltage brown-out protection
Power Consumption
2 W
Mechanism
Installation
DIN-Rail
Dimensions
72mm x 122mm x 33mm (W x L x H)
Environment
Operating Temp.
-25 ~ 75 ℃
Storage Temp.
-30 ~ 80 ℃
Humidity
10 ~ 90% RH, non-condensing
I-7532-G CR
Two-channel CAN Bus Isolated Bridge (RoHS)